lathes, and are the best tools for rough turning. Balanced turning tools will
remove a greater amount of material than any other turning tool available
because of the rugged construction and dual cutting tools. The two high-speed
steel blades cut freely, are inexpensive to replace, and adjustment permitting
proper orientation of the tool bit to the workpiece can be made in a matter of
minutes. Although designed primarily for rough turning, these tools will produce
a good finish cut where a high degree of accuracy and fine finish are not
necessary. Balanced turning tools are often used for finish-turning thread
diameters, and are excellent on all types of material including brass.Cutter adjustment can be easily made in a matter of minutes. The two blades are adjusted to the required diameter. Both blades simultaneously remove the same amount of material, creating a balanced cut. This will produce a good part finish at a reasonable feed rate. Or, approximately 80 percent of the material can be removed with one blade, and the remaining material with the other blade for finish turning. For rough turning, the blades may be set so each blade removes only one-half of the required cut. This is especially productive when removing large amounts of material.
